This standard is intended to simplify drawings and specifies general tolerances for linear and angular dimensions, concentricity and symmetry in four accuracy levels. They are subdivided into f (fine), m (medium), g (coarse) and sg (very coarse). PDF : German : Active : : 60.93 : Add to Cart. By selection of a certain accuracy level, the normal workshop accuracy shall be considered. This standard shall be applied in conjunction with the specifications given in DIN 6932. This standard is intended to simplify drawings. General tolerances according to this standard are used for cold- and warm-formed stamped parts made of flat steel products. ![]() They apply if this standard is referred to in drawings or associated documents (for example, terms of delivery). ![]() This standard hasbeen prepared by NA 026-00-03 AA "Stanzteile" ("Stamped parts") of the Springs, Stamped Parts and Moulded Parts Standards Committee (NAFS) at DIN, the German Institute for Standardization e.
0 Comments
Leave a Reply. |